top of page
Sm Bar Red.png
Med Bar Gray.png
Stucco Add-On Paks.png
Acrylic Add-On Paks.png
Color Paks.png
Dry Color Pack - Red.png
Liquid Color Pack - Red.png

Color Paks

A dry, or liquid color pack add-on designed for Interior & Exterior Finish products.

Product Information

Use For.png

Western Blended Color Paks are color packets of either liquid or dry color pigments designed to achieve a targeted color when combined with a designated finish product that may be suitable for pigmentation. Color Paks are available in different presentations depending of the use.

Color Paks are combined (added-on) to Interior & Exterior Finishes which may be suitable for pigmentation.

Varies according to the finish product. 

Color Paks will replicate the conditions of the Interior or Exterior Finishes they are added onto.

Job Conditions:
Air and substrate surface temperature must be 4 °C (40 °F) or higher and remain so for a minimum of 24 hours.

Surface Preparation:
Substrate surface temperature must be above 4 °C (40 °F) and must be clean, dry, structurally sound and free of efflorescence, grease, oil, form release agents and curing compounds. On painted surfaces, remove all blistered, peeling or lose paint to a sound substrate. Remove gloss by sanding. Concrete should be cured for 28 days.

Mixing with Interior & Exterior Products:
Pour the color pak into the container where you are performing the mix and rinse the residual from the color pak container into the pail. Do not add more than 10 oz (including the color pak) of water into the container. Thoroughly mix both items (color pak & finish) with a Goldblatt Jiffler Mixer until a uniform color consistency is attained. When mixing color paks, check both, the finish product package and color pak container to make sure the designated bases on both labels match.

Follow the application instructions of the desired product finish in which the color pak is going onto.

Clean Up:
Clean tools with water while colored residual is still wet.

Color Paks must be stored at 4 °C (40 °F) or above in tightly sealed containers out of direct sunlight. Liquid color paks shelf life is significantly shorter than dry pigment color paks. Do not use a liquid color pak that has been sitting for more than 6 months.


Shelf Life: 

  • Dry pigment color paks: 1 Year.

  • Liquid Color Paks: 6 Months.

Not for use on horizontal, traffic-bearing surfaces.


Manufacturers or Western Blended Products (WBP) warrants its products to be of merchantable quality and suitable for the general purpose for which they were intended, when applied in accordance with WBP instructions.  Manufacturers of WBP do not warrant its products to be suitable for any purpose or use other than for which they were intended.  Liability under this warranty is limited to supplying new material without charge, or at manufacturers of WBP option, to a refund of the purchase price.  In the event of a claim under this warranty, written notice must be given to the originating plant of the WBP goods at the address shown hereon.  This limited warranty is issued and accepted in lieu of all other expressed warranties, and expressly excludes liability for consequential damages.  Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations and exclusions may not apply to you.  This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

bottom of page