Western Fog Kote
A spray-applied, factory blended coating of pigments, controlled portland cements and additives, for exterior stucco color renovation.
Product Information
Application:
Pour mixed Western Fog Kote through a paint strainer into a garden type sprayer. When applying Fog Kote, use light passes over the wall avoiding runs and material dripping down the surface. To revitalize existing stucco surfaces with the same color two light passes are sufficient. For changing the existing color of stucco - three to four passes may be required.
Small project samples are highly recommended prior to the application of Fog Kote over the surface to ensure the desired color look is achieved.
Limitations:
Do not add any other admixtures without written permission from an authorized manufacturer of Western Blended Products.
Do not apply when surface or ambient temperatures are at or below 40°F / 4.4°C or above 100°F / 34°C. Do not apply to surfaces that are contaminated with bond breakers, oils or other matter that may affect the performance of the product.
Do not apply if conditions are expected to be above or below the specified temperature range within 24 hours of application.
Do not add additional ingredients without specific written approval from an authorized manufacturer of Western Blended Products. Product will freeze at temperatures below 32°F / 0°F. In case of freezing, let thaw slowly at room temperature for several days.
Drying:
Western Fog Kote is normally dried in 24 hours but drying may vary depending upon ambient conditions. Surfaces colored with Western Fog Kote must be protected from inclement weather or other ambient conditions or factors which may affect the performance of the product until fully dried.
Storage:
Product shall be kept indoors preferably. If stored outdoors, it shall be adequately covered to keep dry and must be stored off the ground.
Applicable Standards, Specifications and Codes:
ASTM C150 – Portland Cement
ASTM C926 – Application of Portland Cement-Based Plaster
2024 International Building Code (IBC)
2024 International Residential Code (IRC)
Conditions of Use and Limited Warranty:
Specifications for this product are based on optimal environmental conditions (70°F ambient temperature with 50% humidity) for preparation, mixing, application and curing. Specification parameters may vary as environmental conditions change. Consult the product’s Safety Data Sheet or GHS Section located on the product package for hazard identification and first aid measures. KEEP OUT OF REACH OF CHILDREN.
Western Blended Products (WBP) warrants that its products are of merchantable quality and suitable for the general purpose for which they are intended when applied in accordance with WBP instructions. The manufacturers of WBP products do not warrant the products to be suitable for any purpose or use other than that for which they are intended. Liability under this warranty is limited to supplying new material without charge or, at the option of the manufacturer of the WBP product, refunding the purchase price. In the event of a claim under this warranty, written notice must be provided to the originating plant of the WBP product at the address shown herein. This limited warranty is issued and accepted in lieu of all other express warranties and expressly excludes liability for consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts; therefore, the above limitations or exclusions may not apply.